Lightweight Concrete, Foamed Concrete, Foam Ceramics, Landfill Cover, Foam Coating, Foam Adhesives

1. Allied Foam Tech has been awarded by USCA as the best chem machinery other manufacturer in Montgomeryville, Pennsylvania in 2015, 2014, 2013, and 2011-2009.

2. Allied Foam Tech was awarded a 2016 Gold Medal in Material Science and a 2014 Silver Medal in Applied Technology from EDISON AWARDS

Recent News
February, 2023
(by Advanced Market Analysis Research & Media LLP in evaluating market size, trend, and forecast for global foamed concrete market to 2027)
"Allied Foam Tech was selected as the key player in US for the infrastructure development in the global foam concrete market."

Allied fire barrier foam has the highest compressive and bending strengths
vs autoclaved & cast-in-place foam cement

Cement Composite Cure Condition Density Compr. Strength Bending Strength

AFT Fire Barrier Foam I RT 35 pcf 900 - 1,000 psi 370 - 500 psi

AFT Fire Barrier Foam II RT 35 pcf 650 - 750 psi 300-350 psi

AFT Portland Cem I/II RT 35 pcf 400 - 450 psi 100-200 psi

Autoclaved Concrete Autoclaving 35 pcf 600 - 700 psi 100 psi(?)

(b>
((b>

Allied fire barrier foam has the highest fire rating per ASTM-E-119 Test
against fire rated X-gypsum boards

                          Allied fire barrier foam has twice or better fire ratings per ASTM-E-119 Test
             over all fire rated intumescent coatings

(b>

                          Allied fire barrier foam has twice or better fire ratings per ASTM-E-119 Test
             over all fire rated intumescent coatings

ASTM-E-119 Tested H-Beams with Fire Rated Coatings

H Beam with Allied Fire Barrier Foam
- 4 Hours to 2,000^oF H Beam with Intumescent Coating
- 2 Hours to 1,850^o F

OTHER HIGHLIGHTS

HIGHLIGHT - JANUARY, 2016 (World Trade Center Phase II Project, New York)

Versatile Compact Foam Cement Mixing Pumping Setup - High Mobility with Good Output

World Trade Center, New York - Phase I (December, 2014) & Phase II (January, 2016) Geotech Fill Projects

9/11 Memorial Museum (upper view)
Allied Geotech Setup - Museum in the back Allied Foam Liquid Tanks and Foamer Setup

Two Mixer/Pumpers on Either Side of Allied Foamer Two Pumping Hoses Going Down Geotech Fill for WTC Subway Stabilization

1/3 Yard Mobile Foam Cement Mixer/Pumper above or Other Conventional Grout Mixer/Pumper. Adding Allied Foam to 1/3 Yard Mixer on the left. Grout Pumped through Hose to Indoor Site. Allied Foam Cement Grout over Unprimed Concrete Base. Allied Foam Cement Grout - Screed to Level. Load-bearing Topping Applied over 30 pcf Allied Foam Cement Grout.

Landscape Architechture on the Roof - An application with allied low slump foam cement

Harvard University - NorthWest Science Building, 530,000 ft² multidisciplinary research facility

The World's 1st Low Slump Geotechnical Roof Fill used Allied's Cement Composite Design, Foam Products & Machinery.

The award winning facility places more than half the total square footage of the facility below grade, and incorporates three functioning green roofs. The south facade of the Northwest Science Building defines a new South Yard, equipped with low landscape furniture. The yard is a green roof over extensive basement levels, with skylights bringing daylight into the underground areas.

Landscape Design Landscape on top of the Foam Cement-soil structure Recreation Area under the Foam Cement Composite Night View around the Landscape

(Pre-project mockup work by Allied Foam Tech is shown below)

Mixing & Pumping of High Applying of High Slump Loss Finished Foamed Cement Crown Cross-section of

Slump Loss Foam Cement Foam Cement on 1 Vertical/4 Horizontal Slope On Highly Sloped Geofoam Landscape after ~ 1 year

Foam Concrete and Lightweight Concrete/span> - With densities from over 1,450 kg/m³ (90 pcf) to as low as 48 kg/m³ (3 pcf) for geotechnical engineering & landscape architecture, lightweight concrete roof deck, lightweight wall and floor panels partitions lightweight concrete blocks insulative cinder block inserts.

Flexible Foam Cement Composites - High flexural strength, good Mandrel bending behavior without cracking, good adhesion, exterior durability and excellent water resistance.

Landfill Cover and Odor Control - Allied pervious & non-pervious foamed cement are capable for waste encapsulation, immobilization, soil stabilization and leachate filtration. Allied long lasting foam, applied as a surface cover on landfill sites and effluent ponds and lagoons, will effectively suppress noxious odors, vapors, litter and vectors, avoiding serious environmental issues.

   Lightweight Ceramics - with densities as low as 23 kg/m³(1.5 pcf) for fabrication of insulative and high temperature resistant ceramic foams.
Pervious Cement - Allied chemically engineered open and closed pore properties within their cell structure are very similar to that of urethane and polystyrene foams, but without their associated poor fire resistance, yet with outdoor durability and great cost advantage.
Insulative Firebricks, Panels -with excellent strength and thermal shock resistance for fabrication of durable firebricks used as high performance insulative materials for kilns and incinerators.
Geopolymer, Geotech Applications - Flexible and very light (< 1.5 pcf or 24 kg/m³). Various geopolymer foam composites can achieve insulative value R > 3.8 per inch and fire resistance.

Home| Applications | Products | Sales&Services | Contact
© 2024 Allied Foam Tech Corporation

Cement Composite	Cure Condition	Density	Compr. Strength	Bending Strength
AFT Fire Barrier Foam I	RT	35 pcf	900 - 1,000 psi	370 - 500 psi
AFT Fire Barrier Foam II	RT	35 pcf	650 - 750 psi	300-350 psi
AFT Portland Cem I/II	RT	35 pcf	400 - 450 psi	100-200 psi
Autoclaved Concrete	Autoclaving	35 pcf	600 - 700 psi	100 psi(?)


H Beam with Allied Fire Barrier Foam - 4 Hours to 2,000^oF	H Beam with Intumescent Coating - 2 Hours to 1,850^o F